Ice Maker Repair in Tampa, FL

Bozmanfix provides professional ice maker repair in Tampa, FL, for residential and commercial units across Tampa Bay. Our technicians handle ice production failures, leaks, jams, scaled water lines, and error codes, with same-day visits for calls booked before 2 PM and the next open day for later calls, from South Tampa to St. Petersburg, Clearwater and Brandon.

The median Bozmanfix ice maker repair with a part in Tampa Bay runs $389, the $99 diagnostic is waived when you approve the work, and every visit ends with a straight repair-or-replace answer based on the unit’s age and condition. Company-wide prices by part, built from Bozmanfix invoices, are on our appliance repair parts cost page.

Ice matters in Tampa, and not only because of the heat. Between waterfront condos in Harbour Island and Snell Isle, vacation rentals on Clearwater Beach, and the density of bars, cafés and restaurants along South Howard and Central Avenue, ice is either part of a household routine that runs all summer or part of how a business serves customers.

When production stops in July, the workaround is bagged ice by the cooler, and it gets old fast.

Two local conditions matter for ice makers around Tampa Bay. The first is water hardness: the City of Tampa Water Department’s 2025 water quality report puts the average total hardness of its finished water at 211 mg/L, or 12.3 grains per gallon, well above the 120 ppm level the city, citing the USGS, counts as hard.

Mineral deposits load the water filter and leave scale in the fill tube and the inlet valve behind it. The second is Gulf humidity, which turns every door opening into a moisture load and makes frost bridge across an ice maker module that would stay clear in a dry climate.

Our ice maker repair cost breakdown shows what each failed part actually costs.

Match Your Symptom to the Likely Cause

Ice makers fail in a small number of specific ways, and each symptom points at a different component. Describing the pattern on the call tells the technician whether to expect a filter, a valve or an assembly, so the right parts come on the truck.

• No ice at all, freezer still cold → shutoff arm raised, freezer above 10°F, or clogged filter
• Small, hollow or cloudy cubes → restricted flow, overdue filter, scale in the line
• Faint hum during fill, no water enters → water inlet valve
• Unit cycles but no ice ejects → ice maker module or assembly
• Solid block in the mold → defrost heater inside the module has failed
• Water dispenser works, no ice → inlet valve or module, supply is fine
• Grinding or clicking noise → auger or drive motor
• Water leaking or pooling → fill tube or water line
• Error code on the display → control board
• Reads full when the bin is empty → frosted arm or dirty optical sensor

Ice Maker Problems We Fix in Tampa Bay

• Ice maker not producing ice
• Cubes too small, hollow or cloudy
• Water leaking from the ice maker or freezer
• Ice maker freezing over or jamming
• Grinding, buzzing or clicking noises
• Error codes on the display panel
• Ice bin not filling properly
• Water line scaled, kinked or disconnected
• Commercial machine producing soft or slow ice

Ice Maker Repair Cost in Tampa, FL

The figures below are medians from Bozmanfix’s own completed ice maker jobs, not part prices from a catalog. Each one is the full ticket (part, labor and the service call together), which is the number that lands on your invoice. The $99 diagnostic is waived when you approve the repair, and completed work carries a 90-day parts and labor warranty.

A fill tube and a control board are a $95 difference on the invoice even though the parts are nothing alike. So the useful question is not which component failed, but whether the unit is worth another repair at all.

Trusted Ice Maker Technicians Near You in Tampa

Our technicians service household ice makers and commercial ice machines across Tampa Bay. During each appointment they look past the obvious symptom: the specialist checks water pressure at the inlet, the valve, the fill tube, the tray or auger motor, the temperature sensors and the control board.

If scale or an installation flaw is what keeps causing the failure, Bozmanfix explains what to change so it does not come back.

For property managers running short-term rentals on the beaches, this approach prevents water damage and the review that follows a guest finding a puddle. For restaurant and bar owners, it protects service on a Friday night. For homeowners in South Tampa, Carrollwood or Palma Ceia, it keeps a summer routine intact without a surprise bill.

The recommendation stays honest in both directions. If a repair only buys a worn-out unit a few more months, the technician says so and lays out the options instead of selling a third repair on the same machine.

Ice Maker Maintenance for Tampa Bay Homes and Businesses

In water this hard, the water filter is one of the first parts a Bozmanfix technician checks, and it can be replaced on the visit. A filter loaded with minerals creates backpressure, and the ice maker is the first thing that suffers: cubes get smaller, then hollow, then stop, while the freezer reads perfectly normal. The same restriction makes the inlet valve stay energized longer on every fill, and those coils fail from heat.

On commercial machines, descaling is done during a preventive visit, given how hard Tampa’s water is. On that visit a Bozmanfix technician clears the ice buildup, flushes and descales the water path, tests flow and pressure, checks the temperature sensors, and verifies the harvest cycle completes end to end.

Need Your Ice Maker Fixed in Tampa? Our Local Pros Will Help

Ice maker failures show up at the worst time: before a weekend on the water, ahead of a rental turnover, or in the middle of a dinner service. Scheduling stays simple: you describe the symptom, the dispatcher offers open windows with a clear arrival range, and you pick what fits the day. Calls booked before 2 PM can get a same-day visit, and later calls get the next open day.

Our technicians carry inlet valves, fill tubes, filters and ice maker modules for major brands on the truck, so a repair can finish during the diagnostic visit when the part is on board. Model-specific assemblies for certain Samsung, LG and premium built-in units may need ordering, and in that case you get the part number and the expected date before the technician leaves.

What Tampa Bay Customers Say About Bozmanfix

Commercial Ice Machine Repair in Tampa, St. Petersburg and Pinellas County

Bozmanfix repairs commercial ice machines for restaurants, bars, hotels, workplaces and marinas across Tampa Bay, including Tampa, St. Petersburg, Clearwater, Largo, Palm Harbor, Pinellas Park, Dunedin, Oldsmar, Seminole, Bradenton and Spring Hill. We work on Hoshizaki, Manitowoc, Scotsman and Ice-O-Matic cubers, flakers and nugget machines, plus the under-counter units behind a bar.

A commercial machine that makes thin or soft ice, harvests slowly or stops filling is checked for scale on the water side, a weak inlet valve and a drain that backs up into the bin. The technician names the fault and gives a written price before the repair starts, and the same terms apply in every city listed above. For machines outside Tampa Bay, see our commercial ice machine repair page.

Ice Maker Repair Service Area in Tampa Bay, FL

Brands We Service in Tampa

If you are comparing companies rather than pricing one repair, see how Bozmanfix compares as an appliance repair company in Tampa Bay: service calls, prices by area and how fast a technician gets to you.

Ice Maker Repair in Tampa: FAQ

Ice Maker Repair by Area Near Tampa

Other Repairs We Handle in Tampa, FL

Nearby in the Tampa Bay area: we also publish a separate local page for ice maker repair in Brandon, built on the jobs we have actually run in that community, with its own price band and failure patterns.