Dryer Repair in High Point, NC
Dryer repair in High Point runs a median of $285, with the middle half of jobs between $245 and $320 — the cheapest dryer figure of the three Triad cities we publish. That comes from 16 dryer jobs in 16 separate households, nine paid visits and seven of those ending with work done on the machine.
And there is something in this city we do not see anywhere else: not one of the nine paid dryer visits was an assessment-only invoice. Every one was $200 or more. In Greensboro 12 of 35 paid dryer visits came to the $99 diagnostic, in Winston-Salem 5 of 24. Here, none.
Dryer Repair in High Point — Gas and Electric, 27260 to 27265
Mobile service across every High Point ZIP code with no travel charge inside the city. The $99 diagnostic is applied to the repair once you approve it, and it is $150 on a stacked washer-dryer because two machines share one cabinet and both have to be assessed.
All Seven High Point Invoices
| What the visit did | High Point invoice | Company median | Company n |
|---|---|---|---|
| Part not named on the work order | $229 | — | — |
| Dryer installation | $245 | — | — |
| Part not named on the work order | $265 | — | — |
| Pulley, Samsung | $285 | $349 rollers and idler | 218 |
| Part not named on the work order | $285 | — | — |
| Part not named on the work order | $320 | — | — |
| Heating element, Maytag | $329 | $362 | 360 |
| Control board | none yet | $478 | 71 |
| All High Point dryer work | $285 median, 7 jobs | $352 | 4,218 |
| Assessment-only visits | none of the nine paid visits | $99 | — |
Why High Point Dryer Work Looks the Way It Does
Nine paid visits, nine of them real work NO $99-ONLY INVOICES AT ALL
This is the cleanest signal in our Triad book. When someone in High Point calls us about a dryer, the machine has broken in a way that needed doing — every paid visit ran to $200 or more and seven of the nine ended with work on the machine.
For comparison, a third of paid dryer visits in Greensboro came to the diagnostic alone, and a fifth in Winston-Salem. We are not going to build a theory about the housing stock out of nine visits, but there is a practical consequence: our technicians carry belts, rollers, pulleys and elements on the van for this city, because the odds of needing them are high.
The two named repairs both came in under company $285 AND $329
A Samsung pulley at $285 where our book shows $349 for roller and idler work across 218 repairs, and a Maytag heating element at $329 where the company median is $362 across 360. Those two components — the drive train and the heat circuit — are the two things that actually fail on a dryer, and in this city both cost less than our average.
It is also why the local median of $285 sits $67 below the company figure of $352 across 4,218 repairs.
Whirlpool and Samsung split the local book evenly 5 AND 5 OF 15 BRANDED
Fifteen of the 16 jobs name a brand: Whirlpool five, Samsung five, then Maytag and Kenmore on two each and one GE. Company-wide our dryer work runs Samsung 25.8 percent, Whirlpool 19.3, GE 17.4, Maytag 12.1 and LG 11.3 across 2,524 jobs — so the two local leaders are company leaders too, and LG does not appear in this city’s dryer book at all.
Where it matters to a household is parts: Whirlpool, Samsung and Maytag elements, belts, pulleys and roller kits are commonly on the van or next-day. As always, this is what is installed in High Point laundry rooms rather than a ranking of which brand lasts.
Two thirds of the work in 27265, and no history to lean on 11 OF 16
Eleven of the sixteen dryer jobs sit in 27265, with three in 27262 and two in 27260 — and 27262 turned both its paid visits into work. Across all appliances 27265 holds 43 of our 72 High Point work orders, so the concentration is citywide.
The hard limit: every High Point work order dates from March 2026, when the route opened. Company-wide the dryer has one of the sharpest seasonal curves in our book, peaking in June at 14.0 percent of the year against February at 5.3, and five months of data cannot tell you whether this city follows it.
Two details are worth telling us when you book, because both change what the technician brings: whether the dryer is gas or electric, and whether it is stacked or a combination unit. Gas machines need valve and coil parts on the van, and a stacked pair takes a longer visit because both machines get assessed.
Match Your Symptom to the Likely Cause
- Tumbles but the clothes stay damp, or it needs two cycles — the heat circuit or the vent. Our one local element job was a Maytag at $329 against a company median of $362 across 360 replacements, and the company figure for a no-heat call overall is $368 across 969 jobs. A restricted vent traps heat and eventually destroys the element, so it is worth mentioning at booking when the duct was last cleared.
- No heat at all on an electric machine — the element, the thermal fuse at a company $332, or a cycling thermostat at $350.
- No heat at all on a gas machine — the igniter, the gas valve or its coils. Tell us at booking that the machine is gas so the right parts travel with the technician.
- Loud rumbling, thumping or a squeal that follows the drum — the rollers, the idler pulley or the belt. Our local Samsung pulley job was $285 against a company $349 for roller and idler work. Company median for a noise call is $349 across 601 jobs, and a seized roller will eventually take the belt with it.
- Drum will not turn but the motor hums — the drive belt at a company $322 or the idler. Company median for a not-tumbling call is $335 across 223 jobs.
- Will not start at all, or dies mid-cycle — the door switch at a company $321, the thermal fuse, or the control board at $478. High Point has produced no board job yet. Company median for a not-starting call is $341 across 151 jobs.
- Shuts off after a few minutes — usually a restricted vent tripping the high-limit cut-out rather than a failed part, at a company median of $368 across 34 jobs.
High Point Dryer Work by ZIP Code
| ZIP | Area | Jobs | Paid visits | Work done |
|---|---|---|---|---|
| 27265 | North and west High Point | 11 | 5 | 4 |
| 27262 | Central and west High Point | 3 | 2 | 2 |
| 27260 | Central and south High Point | 2 | 2 | 1 |
| 27263 | Southeast High Point | 0 | 0 | 0 |
High Point sits across Guilford, Davidson, Randolph and Forsyth counties and is the third city of the Piedmont Triad. Three of its ZIP codes appear in our dryer book so far and all High Point ZIP codes are covered at the same rate, with no travel charge inside the city.
We work as a mobile service: the technician comes to the laundry room, and there is no counter or depot to bring a machine to.
Dryer Brands We Are Called To in High Point
| Brand | High Point dryer jobs | Company share of dryer work |
|---|---|---|
| Whirlpool | 5 | 19.3 percent |
| Samsung | 5 | 25.8 percent |
| Maytag | 2 | 12.1 percent |
| Kenmore | 2 | — |
| GE | 1 | 17.4 percent |
| LG | none in the local book | 11.3 percent |
| Branded jobs | 15 of 16 | 2,524 company dryer jobs |
We also service LG, KitchenAid, Bosch, Electrolux, Frigidaire, Amana, Speed Queen and Haier dryers here, gas and electric, freestanding and stacked. On a stacked washer-dryer the diagnostic is $150 rather than $99, because two machines share one cabinet and both have to be assessed to establish which one has failed.
Repair or Replace, in High Point Numbers
Dryers sit at the favourable end of this arithmetic and the local numbers make it plain. A new mid-range electric dryer is $500 to $900 fitted and a gas machine $600 to $1,100, with large-capacity and stacked units above that.
Against those figures a $285 pulley or a $329 element is between a quarter and a half of a replacement, and neither touches the drum or the cabinet, which is what actually determines how long the machine lasts.
One repair is worth pausing over: a control board at a company median of $478 on a machine already past twelve years. High Point has not produced one yet, and if it does we will set that figure next to a replacement quote at the assessment rather than after the back panel is off.
The other thing worth knowing is that a dryer which burns out a second heating element within a couple of years of the first usually has a vent problem rather than a machine problem — that is a duct job, not an appliance job, and no amount of new parts fixes it.
Typical service lives are on how long dryers last, drying speed on dryer not drying fast, heat faults on dryer not heating, and the break-even arithmetic in the repair versus replacement guide.
Discounts Applied Automatically
Priority Membership
$179 a year — five diagnostics, priority slots
- Five free diagnostic visits a year, a $495 value
- Priority scheduling with 24 to 48 hour response
- $30 off labor on every repair
- Extended warranty on all Bozmanfix work
What Customers Say About Our Dryer Work
“Nick was very prompt. My dryer was no longer heating; he took it apart, determined the thermostat had gone bad, replaced it immediately, and we were back up in less than 30 minutes.”
“Max was great. Very nice and professional. Fixed my dryer with no problems. I highly recommend this company.”
“Eugene was amazing! Honest and up front. He ran into a hurdle when cleaning the dryer vent and stuck to it and did an amazing job. I will recommend them to all my neighbors!”
“Oleh was on-time, professional, efficient. Dismantled our clothes dryer and diagnosed the issue (dead heating element) within minutes, plus cleaning and maintenance.”
Dryer Repair in High Point — Questions We Get
How much does dryer repair cost in High Point?
The median is $285, from seven jobs among 16 local dryer visits, with the middle half between $245 and $320. The seven invoices were $229, $245, $265, $285, $285, $320 and $329. Two of the seven name the part — a Samsung pulley at $285 and a Maytag heating element at $329 — and one is an installation at $245 rather than a repair.
Each figure includes the part, the labour and the service call. Our company dryer median is $352 across 4,218 repairs, so High Point runs $67 below it. The diagnostic itself is $99, or $150 on a stacked unit.
Why is High Point cheaper than your other Triad cities for dryers?
Because of what the work has been. Our two named local repairs — a pulley at $285 and a heating element at $329 — both came in under their company medians of $349 and $362, and no control board job has come up here at all.
Greensboro runs $300 and Winston-Salem $315 on the same appliance. The labour rate and the $99 diagnostic are identical in all three cities, so the difference is in the machines and the jobs rather than in the pricing.
What does it mean that none of your visits here was assessment-only?
That every paid dryer visit in this city ran to $200 or more, and seven of the nine ended with work on the machine. In Greensboro 12 of 35 paid dryer visits came to the $99 diagnostic and in Winston-Salem 5 of 24.
Nine visits is too few to explain, so we will not try — but the practical effect is that our technicians carry belts, rollers, pulleys and elements on the van for High Point, because the odds of needing them here are high.
My dryer runs but the clothes are still damp. What is that?
Either the heat circuit or the vent, and both produce the identical complaint. On an electric machine the heat side is usually the element — our one local job was a Maytag at $329 against a company median of $362 across 360 replacements — or the thermostat at $350.
On the vent side, a crushed or restricted duct traps heat, trips the cut-outs and eventually destroys the element. Company-wide we replace 360 elements against 43 vent clearances, which tells you which of the two tends to get caught late.
It is making a loud rumbling noise. Is that expensive?
Usually not. Rumbling, thumping or a squeal that follows the drum is nearly always the rollers, the idler pulley or the belt, and our one local job of that kind was a Samsung pulley at $285 against a company median of $349 for roller and idler work across 218 repairs.
Company median for a noise call as a whole is $349 across 601 jobs. It is worth attending to rather than living with, because a seized roller will eventually take the belt with it and leave you with a drum that will not turn.
Do you install dryers as well as repair them?
Yes, and one of our seven High Point jobs was exactly that, at $245. Installation covers levelling, the vent connection and the electrical or gas hookup, and it matters more than people expect: a dryer vented into a crushed or over-long duct will eventually cost you a heating element, and one that is not level wears its drum supports early.
If you have bought a machine and want it fitted properly, say so at booking rather than describing a fault.
Do you charge more for a stacked washer-dryer?
The diagnostic is $150 rather than $99, because a stacked or combination unit is two machines sharing one cabinet and both have to be assessed to establish which one has failed.
Everything after that is identical: the diagnostic is applied to the repair when you approve it, the 90-day parts and labour warranty applies, and the veteran, senior and new-customer discounts work the same way. Tell us at booking so the right length of visit is scheduled.
How long has Bozmanfix been working in High Point?
Since March 2026. All 72 High Point work orders on our books, including these 16 dryer jobs, date from then, which is why this page publishes an invoice list rather than a seasonal claim — five months is not enough history to say which month dryers fail in this city, even though the dryer has one of the sharpest seasonal curves in our company book.
The company medians quoted throughout come from more than 66,000 jobs across eight metro areas.
Other Appliance Repair in High Point
The rest of our High Point coverage, with the local job counts behind each page.
Appliance Repair in High Point — city hub, all six machines Serving High Point and the wider Charlotte area → View our full service areaBook Dryer Repair in High Point
16 dryer jobs on record since March 2026 in 16 separate households, at a median of $285 — the cheapest of our three Triad cities — with all seven invoices published. Gas and electric, freestanding and stacked. Every ZIP code covered, no travel charge inside the city, 90-day parts and labour warranty.